I think it has some maximum power rating like 200 watts, but there's almost no way I will hit that maximum just powering pedals right? But would it be ok to plug in say the Strymon Timeline and a few other pedals or is that pushing it now? Would it be ok to plug a power strip into the courtesy outlet on the PP2+. What do you think is the best way to go about it?ДЄnd if I end up plugging into outputs 5 and 6 for one pedal and into the courtesy outlet for the other pedal what cable is it I need to connect through the courtesy outlet? Has anyone plugged these pedals or similar pedals into the outputs 5+7 and 6+9 before? (56mm, 59mm and 65mm may be ordered through your local authorized Speedplay dealer) Triple Sealed Cartridge & Needle Bearings. Will throw in the booster plate, which raises pedals for easier access. 33.99 10.5 x 5 booster plate 250 for both pedal board and pedal power. That would be the best way to power both of these pedals from the Voodoo Lab supply Strymon says. 11.5mm (3 hole) 8.4mm (4 hole) Grivory GV-6H. Retail prices for new items are as follows 199.99 plus tax Pedal Train Novo 18 with soft case 239.99 plus tax Pedal Power II Plus with power cables. Then for the the other pedal they recommend using the courtesy output on the back of the Voodoo Lab unit to connect the factory power supply for the other Strymon pedal and power it that way. They recommend using a current doubler (not voltage!) to span outputs 5 and 6 to get 9V, 500mA and to make sure the switch on the bottom is set to NORMAL for 9V. So, they said I will not be able to power both of these pedals directly from the PP2+ outputs. I thought this would give me 350mA but when I asked Strymon about it they didn't recommend it saying that spanning two outputs that are not putting out the same amount of current with a current doubler is not good practice, as they will compete for the output and current may flow into the lower current output, damaging the supply. Can I plug the Timeline into 5+7 on the PP2+ and the Bigsky into 6+8 with the DIP switch set to normal on the back? I want to plug in two Strymon pedals, the Timeline and the Bigsky into the PP2+.

Power pedal 2 plus with timelane